Makers, hobbyists and developers that enjoy building Arduino-based projects may be interested in a new Arduino dual motor controller that has been created by David Baines. The new Arduino-based ...

ECM PCB STATOR TECH is expanding its portfolio for manufacturers seeking to enhance their machinery’s electric power performance, introducing a fully integrated electric-motor controller it reports is ...

Brushless motors are everywhere now. From RC planes to CNC machines, if you need a lot of power to spin something really fast, you’re probably going to use a brushless motor. A brushless motor ...

Over the last few years, [Michael] has been developing a PIC microcontroller board. He calls his project USBPIC, and with the addition of a few FET drivers, H-bridges, and LED drivers his homemade dev ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

The CL3-E-2 stepper and BLDC motor controller board has a continuous output of up to 70 W and is only 40 x 60 mm. It is especially suited for laboratory automation equipment and can run open-loop ...

ST’s demonstration board controls two three-phase brushless motors using an onboard STSPIN32G4 controller with an embedded MCU. The controller’s integrated MCU is based on a 32-bit Arm Cortex-M4 core, ...

Check out a new design kit Raspberry Pi-based motor control, from Ryanteck. The RTK Raspberry Pi Motor Controller Board (RTK-000-001), available from the Adafruit website, uses the module’s GPIO pins ...

Years ago my pal Steve Titus wanted to experiment with some drone rotor designs. He needed a simple motor controller that could operate from 8V to 12V and deliver amperes of current to a DC motor used ...