SunFounder has sent me a review sample of the Fusion HAT+ Raspberry Pi expansion board designed for motor and servo control ...

It’s little secret that stepper motors are everywhere in FDM 3D printers, but there’s no real reason why you cannot take another type of DC motor like a brushless DC (BLDC) motor and use that instead.

Cost Series of 1, 2, and 3-axis Stand Alone Motion Control Systems! Van Nuys, CA — To complement the Optimal Engineering ...

This Motor Controller project is designed to work seamlessly with a differential drive robot Perceptron Bot. It offers a comprehensive suite of features, including a motor driver implementation, a ...

One of the joys of writing for Hackaday comes in following the world of new semiconductor devices, spotting interesting ones while they are still just entries on manufacturer websites, and then ...

This repositary contains motor-control software for Permanent Magnet Synchronous Motor (PMSM) and Brushlees DC Motor (BLDC). The applications can support low-voltage hardware platforms and various MCU ...

The table shows the pin configuration of the Arduino UNO–based robotic arm. The red (VCC) wires of all servos are connected ...

Abstract: The paper proposes a switching multiparametric control for an electrohydraulic servo system with throttle regulation. The architecture of a MISO (Multiple Input Single Output) control is ...

Abstract: Recently, wireless power transfer for electric motor technology has been studied, where the primary side can drive the motor without physical contact, so the load motor can be employed in ...

Brainboxes didn’t just bolt a Pi into a metal box — the company built a factory-grade edge controller that’s designed for ...